Omega OCI64, Инструкция по эксплуатации

Страница: 12 / 17

12
Operating Instruction
Selecting A Cooking Zone
Select a single cooking zone by pressing the corresponding
Heater Selection Button
, and the
Decimal Point
of
the chosen cooking zone turns on. For the selected cooking zone, you can set or adjust the heat level
between 1-9 by touching the
Sliding Button
at the appropriate point. All of the other cooking zone displays will
have a visible ‘O’ or ‘H’ (if recently used) but they will not have a decimal point.
If left idle for more than 10 seconds, the decimal point on the chosen cooking zone display will turn off (the
cooking zone is no longer selected). Press the
Heater Selection Button
again to select the cooking zone
again. Other cooking zones can be selected without waiting for the previous one to become inactive.
The Heat Level Display works on a thermostat system. This means that the cooking zone will switch on and
off in order to remain at the chosen Heat Level.
NOTE the cooking zone will remain on for longer periods if a higher Heat Level is chosen, alternatively the
cooking zone will be on less regularly on lower Heat Level Settings.
Turning Off Individual Cooking Zones
A particular cooking zone can be turned off in 2 different ways:
A) Selecting the cooking zone & then simultaneously pressing the
Sliding Button
at either end at the same
time, after which a beep signal sounds and “0“ appears in the Heat Level Display.
B) Reduction of the heat setting to “0“ by operating the
Sliding Button
to the left. When this happens, the
associated
Decimal Point
of the cooking zone will also be turned off. If there is residual heat from this
hotplate remaining, a red ´H` will be shown in the Heat Level Display area.
The Boost Function
The
Boost
function is available at each cooking zone. It is used to speed up the initial heat up time (say boil a
pot of water). Select a cooking zone and set the Heat level. While the decimal point on the display is lit, press
the
Boost
button. The display will alternate between “P” and the heat setting.
Note: The
Boost
function is not always available (depending on what else is being used), and if the power
requirements are exceeded, the display will flash with an alternative setting for 3 seconds. Do not leave the
appliance unattended while this function is active.
To disable the
Boost
function, press the
Heater Selection Button
for the cooking zone again (so the
Decimal
Point
is lit) and adjust the heat setting with the
Sliding Button
. The display will no longer alternate between “P”
and the heat setting.
The Smart Pause Function
This function reduces the power of all cooking zones for 30 minutes (at which point the appliance will turn off).
Activate by pushing the
Smart Pause Button.
The displays will alternate between “ " “ and their correct
reading. Turn the function off by pressing the button a second time.