![background image](http://html1.mh-extra.com/html/omega/ocg62xa/ocg62xa_installation-operation-and-maintenance-instructions-manual_3980516007.webp)
LUBRICATION OF THE GAS TAPS
This can only be performed by an authorized person. It may be required if the gas taps become stiff and
difficult to turn.
LEAK TESTING
1.
Make sure gas control knobs are Off and turn the cylinder valve On.
2.
Check for leaking joints by brushing with solution of half-liquid detergent and half water. If a leak is
present, bubbles will appear (or you may hear a hissing sound). Retightening connections can generally
repair a leaking joint. You must also check the gas hose and connection at the gas cylinder. If a leak
cannot be resolved, do not proceed.
DO NOT USE NAKED FLAME FOR LOCATING GAS LEAKS.
IF A LEAK PERSISTS CALL AN AUTHORISED GAS FITTER.
ELECTRICAL CONNECTIONS
LOCAL AUTHORITY REQUIREMENTS
Installation is only permitted by an authorized person, and carried out according to instructions provided by the
manufacturer. Incorrect installation might cause harm and damage which the manufacturer accepts no
responsibility. The electrical connection can be found centrally along the back rear edge of the appliance.
INSTALLATION
This cooktop must be connected to a 220-240V 50Hz power supply. It is earthed via the cord.
Before carrying out the connection to the power supply, the voltage rating of the appliance (stamped on the
appliance identification plate) must be checked for correspondence to the available mains supply voltage, and
the mains electric wiring should be capable of handling the hob’s power rating (also indicated on the
identification plate);
The power point must be connected to a suitable earth wiring, in conformity to current safety regulations.
Ensure that the power supply is within 900mm of the cooktop. The power supply cord must not touch against
any hot surfaces and must be placed so that its temperature does not exceed 75 degrees C at any point along
its length.
The colours of the wires in the hob power cable may not correspond with the colours marked on the terminals
of your electrical plug .The plug should in any case be wired as follows:
—connect the green/yellow wire to the terminal marked with the letter E or the earth symbol or coloured
green/yellow;
7