Omega OC64TB, Инструкция по эксплуатации

Страница: 7 / 14

7
Installation
Electrical Connection
WARNING : The electrical connection of this appliance should be carried out by an authorised
service person or qualified electrician, according to the instructions in this guide and in compliance
with the current local regulations.
WARNING: THE APPLIANCE MUST BE EARTHED.
• Before connecting the appliance to the power supply, the voltage rating of the appliance
(stamped on the appliance identification plate) must be checked for correspondence to the
available mains supply voltage, and the mains electric wiring should be capable of handling the
appliance’s power rating (also indicated on the identification plate).
• During installation, please ensure that isolated cables are used. An incorrect connection could
damage your appliance. If the mains cable is damaged and needs to be replaced this should be
done by a qualified person.
• Do not use adaptors, multiple sockets and/or extension leads.
• The supply cord should be kept away from hot parts of the appliance and must not be bent or
compressed. Otherwise the cord may be damaged, causing a short circuit.
• If the appliance is not connected to the mains with a plug, an all-pole disconnector switch (with
at least 3 mm contact spacing) must be used in order to meet the safety regulations.
• The fused switch must be easily accessible once the appliance has been installed.
• Ensure all connections are adequately tightened.
• Fix the supply cable in the cable clamp and then close the cover.
• The terminal box connection is placed on the terminal box.
IMPORTANT
: The figure shows the connection details and minimum diameters of supply cables that must be used for both single
and three phase connections.
• The oven is to be connected to a 220-240Vac 50Hz supply or 3 phase 380-415Vac 50Hz supply.
It is earthed via the supply cord. The earthing cable must be connected via the screw with the
earthing mark.
• For the touch controlled vitro-ceramic hob, the cable must be H05VV-F 3X2.5 mm2 / 60227 IEC
53. You will find the connection diagram shown on the back of your appliance.
• During installation, please insure that isolated cables are used. An incorrect connection might
damage your appliance. The guarantee will not cover such damages.
• All repairs must be carried out by an authorised service personal or a qualified electrician.
• Unplug your appliance before performing maintenance. For reconnection, follow the connection
diagrams strictly.