4.2 Setting a New IP Address over the Network
Besides using the iCONNECT software, you may use the iServer’s default IP address to
access it and assign a new IP address to it.
The iServer is shipped with a default IP address of
192.168.1.200
and Subnet Mask of
255.255.255.0
. You can configure your PC’s Network connection with an IP address that
is in the same range as the iServer’s IP address (
192.168.1.x
) and connect to the iServer
using a crossover network cable between your PC and the iServer.
With this completed, you can go to the DOS-Prompt and ping
192.168.1.200
. If you
receive responses back (
Figure 4.1
), you can go to a Web browser and type in
http://192.168.1.200
and it will take you to the iServer’s main web page.
Select Access Control button, you’ll be asked for the password. The default Login
password is "
12345678
" and the Admin password is "
00000000
", then you should be on
the Access Control page were you can simply type in the desired Static IP address, and
click Save.
Figure 4.4 Access Control
For the IP address to take effect, the iServer needs to be turned OFF/ON or pressing the
physical button marked “RESET” on the iServer
You can now connect the iServer to an Ethernet hub using a straight through cable,
power it up, and follow the ping routine mentioned in the previous section.
Refer to
Section 4.12
for detailed descriptions and functions of the Access
Control Page.
ACCESS CONTROL
ACCESS CONTROL
http://192.168.1.200
Address
Main Menu
Login Password 12345678
Admin Password 00000000
IP Address
192.168.1.200
Gateway Address
0.0.0.0
Subnet Mask
255.255.255.0
MAC Address 00:03:03:00:21:D9
Host Name
eis21d9
Save
Reset
Power Recycle
15
Содержание iServer Microserver
Страница 2: ......
Страница 6: ...Table 4 2 List of Communication Commands 43 iv...
