![background image](http://html1.mh-extra.com/html/omega/ibthx/ibthx_user-manual_737289010.webp)
2.2 DIP Switches
2.2.1 DIP Switch Usage
The iServer is shipped with all DIP switches in
"OFF"
position.
1) N/C - not used
2) To change to default factory settings
3) To enable/disable DHCP
4) N/C - not used
To set the iServer to factory default settings, slide DIP switch #2 to ON position.
Power the iServer on and wait about 10 seconds until the iServer fully boots up.
Set the DIP switch #2 back to OFF position (it does not matter if the iServer is
powered ON or OFF, just make sure that the DIP switch is set to OFF, otherwise,
every time the unit is power-cycled the factory settings will take over.
To enable the DHCP, besides using DIP switch #3, set the iServer’s IP address
to 0.0.0.0. An iServer with IP address of 0.0.0.0 will request an IP address,
gateway address, and subnet mask from a DHCP server over the Ethernet.
Figure 2.4a DIP Switch
Figure 2.4b DIP Switch
Wall Mount iServer
DIN Rail iServer
1
4
3
2
OFF
ON
1
4
3
2
OFF
ON
SW1
SW1
OFF
ON
4
3
2
1
SW1
OFF
ON
4
3
2
1
SW1
6