7. INTRODUCTION OF MAIN DISPLAY
Left hand side shows reading of each channel
with unit at right-upper corner.
When measure with thermocouple, the type of
thermocouple is shown at left-upper corner.
Right hand side shows maximum (MAX),
minimum (MIN), range (MAX-MIN) and aver-
age (AVG) value of readings, and times of
maximum and minimum value occur.
•
Click the button to holds the current reading.
•
Click the button to reset the reading and time of
MAX, MIN & AVG..
•
Click the bottom to activate out of limit alarm.
Hi/Lo limit values are set in 6.
Wireless Features:
Frequency range:
910~920MHz. (Model HH8XX)
868.1~868.5MHz. (Model HH8XXE)
Low current consumption less than 1mA.
The transmitting distance can reach 25M without
magnetic interference.
FEDERAL COMMUNICATIONS
COMMISSION
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired opera-
tion.
NOTE
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection. This equipment gener-
ates, uses and can radiated radio frequency energy and,
if not installed and used in accordance with the in-
structions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation If
this equipment does cause harmful interference to ra-
dio or television reception, which can be determined
by turning the equipment off and on, the user is en-
couraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
receiver.
- Connect the equipment into an outlet on a circuit dif-
ferent from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV tech-
nician for help.
Shielded interface cables must be used in order to
comply with emission limits.
Changes or modifications not expressly approved by
the party responsible for compliance could void the
user‘s authority to operate the equipment.
Comport Confirmation
Procedure
1. Confirm to see if the port (COM&LPT1) of PC
is assigned to the meter like the following illus-
tration, but it could be other Comport not
COM6.
2. If it is normal, then the change of the port
(COM&LPT1) of PC must follow the following
step to make Comport changes.
Setup1. Click on the Properties of the red frame.
Step2. Choose the Advanced of the red frame as
the illustration blow
Step3. Choose Comport other than COM10,
COM3 and the COM without “IN USE”
like the illustration below.
Step4. Complete the above steps and re-scan the
device. And start opening the software to
do Auto-Connection.
