manualshive.com logo in svg
background image

Feature #11   Alarm Duration

Factory Default Setting

30 Seconds
(

press

 

arm/lock” button to program

)

Options:
60 Seconds

(

press

 

disarm/unlock” button  to program

)

90 Seconds

(

press “

II

” button to program

)

120 Seconds

(

press

 

III

” button  to program

)

This feature allows four choices of the Alarm Duration, which is the period of time
for which the system sounding the siren (and/or horn, optionally) and flashes the
parking lights when it is triggered.  Caution: Before lengthening the Alarm
Duration you should always check and determine if there are any local anti-
noise or nuisance ordinances in your area, to avoid the possibility of receiving
a violation citation.

Feature #12   Parking Light Illumination Upon Disarm

Factory Default Setting

On      (

press

 

arm/lock” button to program

)

Option:

Off      (

press

 

disarm/unlock” button to program

)

 

This feature affects the parking light operation when the

 

system is disarmed.  When

this feature is turned on, the parking lights flash once, and then turn back on for
external illumination  for 30 seconds unless the ignition key is turned on during that
time.  If this feature is turned off, the parking lights flash once only, and do not
illuminate.  This feature only affects the Excalibur’s parking light operation, and not
the interior light operation.

Feature #13   2nd Channel Also Disarms System

Factory Default Setting

On      (

press

 

arm/lock” button to program

)

Option:

Off      (

press

 

disarm/unlock” button to program

)

“2nd channel” is most commonly used to remotely open the

 

vehicle’s trunk, in

which case the alarm should also disarm.  This feature, turned on, configures the
system to disarm when the 2nd channel is used.  If turned off, the 2nd channel output
will still occur, with 2 chirps, but without the parking light flashes; and if armed, the
system will not disarm.

Feature #14   3 or 45 Second Arming Delay

Factory Default Setting

3 Seconds
(

press

 

arm/lock” button to program

)

Options:
15 Seconds

(

press

 

disarm/unlock” button  to program

)

30 Seconds

(

press “

II

” button to program

)

45 Seconds

(

press

 

III

” button  to program

)

When the system is armed, whether by the transmitter or by an automatic feature,

Page - 26

Arming Using the Transmitter

The system can always be armed from the transmitter if the ignition key is “off”

and the system is not in the Valet Mode.  To arm the system, exit the vehicle, close
all of the doors, and simply press and release the “arm/lock” button once.

Your Excalibur system is designed to deter theft of both your vehicle and its

contents.  “Arming” your system turns on the protection, disabling the vehicle’s
starter and locking the doors.  Once the system is Armed, any intrusion attempt will
Activate it, sounding the electronic “Psyren” psycho siren and flashing the parking
and interior lights to attract attention.  The unique and patented “2-in-1”  Psyren
psycho siren actually produces the sounds of two different sirens at once, ensuring
that it won’t be ignored like all of the other “common” car alarms.  Disarming

 

the

system turns off the protection, unlocking the doors and turning on the parking and
interior lights, allowing lighted access to, and normal use of, the vehicle.

There are two methods of arming the Excalibur:
1-

The first method is to use the transmitter, by pressing and releasing the
arm/lock” button.  The system must not already be armed or be in Valet Mode,
and the vehicle’s ignition key must be off.

2-

The second method is Last Door Arming, which configures the system to
automatically arm itself every time you exit the vehicle.  This method of arming
is programmable, and may be used or not used as desired.

Using  the  Excalibur  System

Regardless of how it became armed, if the system is armed the Status Light flashes
in a slow, steady manner.

The system’s reaction:

   The parking lights will flash once, the siren will chirp

once and the Status Light will begin to flash, confirming that the system is armed.*
In addition, the doors will lock and the starter interrupt will engage to prevent any
attempt to start the vehicle.  Your security system is now fully armed, and is ready
to respond if an intrusion attempt is detected.

Page - 7

*The system is described in its most common and basic configuration, with
doorlocks connected, and the interior lights connected.  Also, the vehicle horn
may used in place of, or in addition to, the system’s electronic siren.

The Excalibur system’s separate “arm/lock” and “disarm/unlock” button

design allows repetitive operation- if already armed, pressing the “arm/lock” button
will simply rearm the system, and vice versa when pressing the “disarm/unlock
button.

Содержание Excalibur AL-1000-EDP

















Отзывы: