Step 1:
Draw a level line on the wall centered where
the Range Hood is to go 6 ” above where the
bottom of the Range Hood will be (See figure
1). A distance of 24-30 inches from the stove
top to the wood hood is recommended. Check
local building codes and regulations for final
determination.
Step 2:
Screw the mounting plate to the wall matching
the bottom of the mounting plate to the line on
the wall. Make sure to hit at least two studs
and to use at least 6 screws of sufficient size
and length for the application (See figure 2).
Warning
: Failure to fasten this panel to studs
or using the wrong screws may cause a failure
of the mounting system and possible injury.
Assembly Instructions
Assembly Instructions
Figure 1
Figure 2
Step 4:
Remove the face plate and filters from the
Omega National Products Blower and insert
the blower into the liner from below. Using the
4 holes in the side of the blower that corre-
spond to the holes in the liner, attach the blow-
er to the liner and rangehood assembly with 4
each #6 x 1/2” screws. (See figure 4).
Figure 4
Form OME-086, 08/2012
©Omega National Products
Step 3:
If not installed after the Range Hood Was fin-
ished, attach the Liner to the Range Hood
with #6 x 1/2" Truss Head Screws (See figure
3).
Figure 3
