Operating the Pump Motor in the RUNNING Display Mode
6
6-17
6.4.1 Pumping in the TOTAL VOLUME Mode
To pump fluid in the
TOTAL VOLUME Mode
, do the following:
1.
Set up the pump motor for pumping, according to Chapter 3.
2.
Toggle the
ON/OFF switch
to turn on the unit’s power. The display is in the
STOPPED Display Mode
. Refer to Figure 6-7.
3.
Using the procedure outlined in Sections 6.1.1. and 6.2.1, adjust either the
RPM or FLOW RATE setting.
4.
When the display flashes the RPM or FLOW RATE setting you desire, press the
TOTAL VOLUME key
.
The display flashes the current TOTAL VOLUME setting (xxx mL or xxx Liters).
5.
Use the
UP and DOWN ARROW keys
to enter the TOTAL VOLUME setting you
desire. Refer to Figure 6-8 for the TOTAL VOLUME range.
Figure 6-8. TOTAL VOLUME Range
Range
1 mL
2 mL
.
999 mL
1,000 mL (1 L)
.
9,999 L
10,000 L
Range
10,000 L
9,999 L
.
1,000 mL (1L)
999 mL
.
2 mL
1 mL
xxx mL or xxx Liters
ACTION
TOTAL VOLUME setting scrolls down
Display shows
ACTION
TOTAL VOLUME setting scrolls up
xxx mL or xxx Liters
Display shows
xxx mL or xxx Liters
TOTAL
VOLUME
ACTION
Displays current
TOTAL VOLUME
setting
Display shows
Содержание OMEGAFLEX FPU5-MT-110
