Omega Engineering hot point CL900A Series, Руководство пользователя, Страница: 9 / 28

2-1
Installation
2
Section 2 - Installation
2.1 Unpacking
Remove the packing list and verify that you have received all your equipment. If
you have any questions about the shipment, please call our Customer Service
Department at
1 -800-622-2378 or 203-359-1660
W
ebsite: http://www.omega.com
e-mail: info@omega.com
When you receive the shipment, inspect the container and equipment for any
signs of damage. Note any evidence of rough handling in transit. Immediately
report any damage to the shipping agent.
NOTE:
The carrier will not honor any damage claims unless all shipping material is saved for
inspection. After examining and removing contents, save packing material and carton in the
event reshipment is necessary.
The following items are supplied in the box: The following items are supplied in
the box:
*A probe well insert is only included with Model CL900A or CL900A-230.
2.2 Mounting
Mount the unit on a bench, table top or shelf in a horizontal position and operate
at least ten inches from any air obstructions to the fan, front panel, rear panel,
bottom and top of the unit, in an ambient environment between the specified
5°C to 38°C (40°F to 100°F).
2.3 Ambient Temperature
The CL900A/CL950A is designed to operate within an ambient temperature
range from 5°C to 38°C (40°F to 100°F). Failure to operate the unit within this
range may damage your unit. If the unit is operated in an ambient temperature
above 38°C (100°F) a thermal cutoff switch will cut off power to the heater. The
process variable (PV) will no longer approach the setpoint variable (SV). The
heaters will cool down and cease to operate. If this should occur you should
send your unit back to OMEGA for service.
Item: OMEGA Part #:
Hotpoint Calibrator(Removable single port well insert) CL900A /CL900-230
Or Or
Hotpoint Calibrator (Built-in multiport well) CL950A /CL950-230
Probe Well Insert for1/4" Probes (shipped with CL900A)* CL906
Or Or
Probe Well Insert for 4.5 MM Probes (shipped with CL900A-230) * CL906-M
User Manual M-3555
Calibration Certificate CAL-3
Power Cord 200-0028 (Domestic),
200-0107 (International)
Well Insert Removal Tool HP-0037 (CL900A only)