OMEGA ALTISE
CONTROL PANEL:
The main control panel is at the top of the body, with the digital display just below it. The
functions available on the control panel are repeated on the remote control. There are 5
buttons on each:
a)
On/Speed button – Press the button once to turn the fan on (low speed - 1). Press a
second time to change the speed to medium (2), and a third time to change the
speed to high (3). Press the button one more time to change the speed back down to
low, and the sequence repeats itself. The speed is displayed on the digital display.
b)
Off button – Press this button once to turn the fan off.
c)
Timer button – The timer is used to turn the fan off after a pre-determined length
of time. With the fan running, press the Timer button once to set up a time of 0.5
hours. Keep pressing the button to increase this by 0.5 hours, up to a maximum
time of 7.5 hours. To turn the timer off, press one more time (the time=0 hours).
The Timer icon on the digital display will light up and the remaining time shown
by adding the different times up (ie 5.5 hours has the 4h, 1h & 0.5h icons lit).
d)
Swing button – The fan has a number of different oscillation options. The default
is stationary (no oscillation). Press the Swing button once, and the head of the
fan will oscillate from left to right. Press a second time and the head of the fan
will oscillate up and down. Press a third time and the head of the fan will
oscillate in a figure of 8 pattern. Press a fourth time and the oscillation will stop.
These are all shown on the digital display.
e)
Wind Mode button – There are three modes for the fan speed:
a)
Normal – This is the default mode. The fan speed stays at a constant rate (as set by the On/Speed button), the
oscillation continues as set by the swing button and the fan will run continuously unless the timer is set or the Off
button is pressed. When this mode is running, the digital display shows a fan icon.
b)
Natural – The fan speed will alternate to give a more natural feel to the air flow. Oscillation and timing are not
affected. Reducing the speed setting will change the fan speed pattern (overall less air flow). When this mode is
running, the digital display shows a tree icon.
c)
Sleep – The fan speed will alternate in the same way as for the natural mode, except that it will drop one speed
setting every half an hour until the unit reaches the lowest level. When this mode is running, the digital display
shows a moon icon.
If no buttons are pressed for half an hour, the display will go into power saving mode (the bottom icon will light up & all other
icons will turn off). Pressing a button will turn the icons back on.
CLEANING & MAINTENANCE
WARNING:
ALWAYS UNPLUG THE CORD BEFORE MOVING OR SERVICING, DO NOT
IMMERSE APPLIANCE IN WATER!
The fan should be cleaned periodically (at least once a month depending on the build-up of dust).
Clean the body of the pedestal fan with a soft damp cloth. Always make sure that the appliance is completely dry before
connecting back to the mains supply.
CAUTION: Do not use gasoline, benzene, thinner, harsh cleaners, etc. as they will damage the pedestal fan. NEVER use
ALCOHOL OR SOLVENTS.
Remove the front guard and take out the fan blades. Wash under water, rinse & dry. Replace fan blades and front guard.
Do not disassemble the fan in any other manner.
STORAGE: Store the pedestal fan with these instructions, in a cool, dry place with a cover over it.
A division of Shriro Australia Pty Ltd
104 Vanessa St Kingsgrove NSW 2208
In Australia: 1300 795 572
In New Zealand: (09) 415 6000
www.omegaaltise.com
IM Ref: OP408R 29/2014/05
