Omega Altise APC15, Руководство пользователя

Страница: 13 / 13

omega altise
3. End of Season
•
Pull out the plug from the drain outlet and remove any water from the internal bottom water tank. You
can remove the water entirely by slanting the unit backwards.
•
Run the unit in Fan mode for several hours to ensure the inside of the unit is dry.
•
Switch off the unit and disconnect the plug from the power supply.
•
Remove the flexible exhaust duct and adapters and keep stored in a safe dry place.
•
Take the batteries out of the remote control and keep in a dry place.
•
Wrap the unit with the plastic bag, and keep it in a dry place.
Trouble Shooting
Before contacting a professional please read the following troubleshooting guide.
Issue Reason Solution
No power supply
Check the unit is plugged in properly, turn the
power on and turn the unit on.
The LCD is flashing P2 .
Turn the power off, drain the water tank and restart
the unit. The unit does not work
Timer function is active Cancel timer function.
In direct sunlight Draw the curtains
Windows/doors open, many people or a
heat source in the room. Close windows/doors; remove the heat source if
possible.
Dirty filter. Clean the air filter(s).
Air inlet or air outlet is blocked. Remove any blockage.
The unit does not seem to
perform
Ambient room temperature is lower than
the selected value.
Change your temperature selection.
The unit is not on a hard or flat surface.
Place the unit on an even, solid surface (less
vibrations)
The unit is noisy
The unit is on a tiled surface Mount the unit on a rubber or carpeted base.
The compressor does not
work
The overheat protection may be activated.
Turn the unit off, wait 3 minutes until the
temperature has decreased, then turn the unit on
again.
The exhaust tube is attached incorrectly or
is bent. Set the exhaust tube correctly as indicated in the
installation section.
The unit starts and stops
frequently
You have added an extra flexible exhaust
hose
Remove the extra hose.
Distance is too great.
Remote control signal not detected by the
control panel.
Make sure the remote control is correctly aimed at
the control panel.
The remote control does not
function
The batteries are drained. Replace the batteries.
The LCD is flashing E1, E2, E5
Turn the unit off and call your service provider on
1300 739 033.
Error code appears
The LCD is flashing df - Low temperature /
Frost protection
The unit will run in fan mode until the defrosting of
any ice is complete.
CAUTION: Switch off the unit and unplug it immediately if anything abnormal occurs. Then
contact the omega Altise Customer Care Line on 1300 739 033.
WARNING! Do not attempt to repair the unit yourself. Doing so could void the warranty and
cause damage or personal injury.
Omega Altise products are distributed in Australia by MEA, (A Division of Hagemeyer Brands Australia Pty Ltd)
ABN 28 001 375 686, Locked Bag 4013, Kingsgrove NSW 2208
Phone: 1300 739 033 Fax: 1800 838 899 Email: customerservice@meaappliances.com.au Web: meaappliances.com.au
13