Omega Altise APC15, Руководство пользователя

Страница: 12 / 13

omega altise
12
Water Drainage
When the water tank is full, the WATER FULL indicator will illuminate and the compressor will stop working.
A buzzer will sound 10 times every 5 minutes until the water is below the high level or drained.
Before you empty the unit you will need to:
1. Turn the unit off and pull the plug out of the power supply.
2. Place a water tray or pan under the drainage port. (Fig. 10)
3. Remove the plug on the drainage port into and drain into
the vessel beneath.
4. Once drained, replace the plug into the drainage port.
5. Plug the unit back in and switch it on. The compressor will
delay restarting for three-minutes and then continue to work
as normal.
Fig. 10
Important! It is recommended that you do not move the unit around without firstly draining
the internal tank. If water is left in the unit then it may spill out onto the floor or carpet.
Maintenance
Cleaning
Turn off the unit and pull the plug out of the socket before cleaning.
1. Clean the surface
•
Clean the surface of the unit with a duster or a damp soft cloth.
•
Do not use chemical solvent like benzene, alcohol, gasoline and etc, or the surface may be damaged.
2. Clean the air filter
•
The air filter should be cleaned every two weeks
•
If the air filter is blocked with dust the efficiency of the unit will be
reduced.
•
To clean the air filters
1. Pull out the air filters as shown in Figure 11.
2. Wash the air filter by immersing it gently in warm water (under
40
0
C or 104
0
F) with neutral detergent.
3. Rinse the filter and dry it in a shaded place.
4. Push the air filter back into the original position.
5. Alternatively suction the filters using a vacuum cleaner with
the dusting brush attachment to remove any build up of dust or
debris on the filters.
Fig. 11