omega altise
4
Attaching the wall mounting bracket
What you will need:
1. Screwdriver
2. Pencil/pen to mark the drill holes on the wall
3. Drill
4. 4 x screws for fixing (Suggest 4mm expansion screws
for most installations).
IMPORTANT:
Only use the wall mounting bracket supplied
with the unit. For your convenience, the wall mounting
bracket is oriented centrally on the back of the unit.
Figure 3.
1. Loosen the small screw used to fix the wall mounting
bracket to the back of the unit located on the top right
hand side looking from the back. Place to one side.
2. Slide the wall mounting bracket down and away from
the unit.
3. Using the wall mounting bracket as a template for
positioning, place the bracket on the bottom of the wall.
Mark the screw-holes through the holes marked
A
and
B
as shown in Figure 3.
4. Raise the bracket so that the holes marked
C
and
D
are aligned with the marks already made on
the wall in Step 3. Mark the upper holes through holes
E
and
B
as shown in Figure 4.
Figure 4.
5. Drill the four holes into the wall as marked. 4mm
expansion screws are suggested for use to secure the
wall-mounting bracket to the wall.
6. The unit can now be hooked onto the wall mounting
bracket through the four slots on the back. Please refer
to the Figure 5.
7. Replace and tighten the small screw used to fix the
wall mounting bracket to the back of the unit.
8. To remove the unit reverse the above steps.
Figure 5.
TO ATTACH THE CASTORS TO USE THE
PANEL AS A PORTABLE HEATER
Parts list
Support (2pcs) Castor (4pcs) Clip (2pcs)
1. Press 2 castors into the bottom of each of the supports
as shown to the right
2. Turn the body of the unit upside down, with the front of
the unit facing away from you.
3. Place the support over the base so that the securing
hooks line up with the grille on the bottom
4. Slide the support towards to front of the unit making
sure that both lines of securing hooks are firmly in
place over the base cut outs.
5. Secure in place with the clip. Some force may be
necessary.
