OMEGA ALTISE
CONTROL FUNCTIONS
GETTING STARTED
1. Carefully remove the heater from packaging and the carton, and unwind the cord to its full length.
2. Either fit the castors & place the heater onto a stable, flat and dry surface, or fit the mounting brackets to a stable
wall & hang from the wall in a dry position away from open or running water. See installation sections for
details.
3. Turn the heater off at the power switch (on the right hand side of the unit). Plug the cord set into a
220-240V~A.C. 50Hz electrical outlet. Turn the power on at the electrical outlet.
4. Turn the heater on at the power switch (on the right hand side of the unit).
The power indicator will light up (but
no LED display) indicating the unit is in “stand-by mode”. If the LED is lit up, press the “power/set” button for 3
seconds to put it into “stand-by mode”. The heater is now ready for use. Refer to the operating instructions
section further in this manual for the full operation of your heater. The power indicator will remain lit until the
power switch on the heater side is turned off or the heater is unplugged from the electrical outlet.
NOTE: When the heater element is working, the indicator B4 will be lit. Once the heater has reached its required
temperature, the element is turned off & the indicator B4 also turns off.
NOTE: Heater must have castors fitted or be attached to a wall before use.
A. POWER INDICATOR
1. TEMPERATURE SELECT BUTTON
B1. NUMERIC DISPLAY
B. LED DISPLAY
2. POWER/SET BUTTON
B2. LOW POWER INDICATOR
3. UP BUTTON
B3. HIGH POWER INDICATOR
4. DOWN BUTTON
B4. HEATER RUNNING INDICATOR
B5. TEMPERATURE SET INDICATOR
B6. TIMER SET INDICATOR
