SAFETY FEATURES
1. A thermal overload protector is built in to prevent overheating.
2. When an overheat temperature is reached, the heater will automatically shut off. It can only resume operation
when the user resets the unit (see reset instructions below).
To reset your heater:
1. Unplug the heater and wait between 5-10 minutes for the unit to cool down.
2. Then, turn on the unit again and operate normally.
A tilt switch is built into this appliance. If tipped over the appliance will shut off. Right the appliance to restart.
CLEANING & MAINTENANCE
WARNING:
ALWAYS UNPLUG THE CORD BEFORE MOVING OR SERVICING, DO NOT
IMMERSE HEATER IN WATER!
Clean the body of the heater with a soft damp cloth. Always make sure that the heater is completely dry before
connecting back to the mains supply. Remove the rear filter and blow out any dust – do not wash with water.
CAUTION: Do not use gasoline, benzene, thinner, harsh cleaners, etc. as they will damage the heater. NEVER
use ALCOHOL OR SOLVENTS.
STORAGE: Store the heater with these instructions in the original packaging, in a cool, dry place.
WEEE WARNING
This product should not be disposed of with household waste. Please recycle where facilities exist and
check with your local authority for recycling advice.
OMEGA ALTISE
TIMER
The timer can be set as an auto-start or as an auto-stop function.
Auto-start: Keep the appliance in standby mode and press the Timer button (C3). The Timer indicator (D9) will light
up and the Temperature/Timer indicator will start to flash showing the remaining time before the appliance will
turn on. Use the Decrease Function button and Increase Function button to adjust the desired time. Leave for 2
seconds to allow it to set (display stops flashing), and the appliance will turn on the previously set function after the
time has elapsed.
Auto-stop: Turn the appliance on and set the required functions. Press the Timer button and set the time to stop as
above. Once set, the appliance will continue to operate until the time runs out and the appliance returns to standby.
The Timer can be cancelled by pressing the Timer button again.
The preset Timer steps are 0.5Hr, 1.0Hr, 2Hr, 3Hr…22Hr, 23Hr, 24Hr, 0.
