OMEGA ALTISE
GENERAL HEATER PARTS
Display
Control
Handle
Panel
Front Grill
Air Inlet Grill
Main Power Switch
Base
GETTING STARTED
1. Carefully remove the heater from the plastic bag and the carton, and unwind the cord to its full length.
2. Place the heater onto a stable, flat and dry surface. Do not place the heater directly on carpet as the heat
generated may damage some carpets.
3. Set the main power switch to the off position. Plug the cord set into a 220-240V~A.C. 50Hz earthed electrical
outlet. Turn the power on at the electrical outlet and turn on the main power switch.
PLEASE NOTE: The heater will only operate if the thermostat is set to a higher temperature than the
temperature of the room it is in.
CONTROLS
C1
On/Standby button
C2
Mode Select button
C3
Timer button
C4
ECO Mode button
C5
Oscillation button
C6
Decrease Function button
C7
Increase Function button
① ② ③ ④ ⑤
⑥ ⑦
WARNING: To avoid danger of electric shock, unplug from outlet when not in use and before cleaning. If the
supply cord is damaged, it must be replaced by the manufacturer, its Service Agent or similarly
qualified persons in order to avoid a hazard. In order to avoid overheating, do not cover the
heater. The heater must NOT be located immediately below a socket outlet. Do not use the
heater in the immediate surrounding of a bath, shower or swimming pool.
23. If the supply cord is damaged, it must be replaced by Omega altise service center, in order to avoid a hazard.
24. CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal cut-out, this appliance must not
be supplied through an external switching device, such as a timer, or connected to a circuit that is regularly switched
on an off by the utility.
