ECDh-5 - Installation and operating manual
6
www.omega-air.si
1.
It is recommended to apply thermally conductive paste to the junction surface to
enhance heat transfer.
2.
Place the heater to the bottom of the drain housing. No washer is needed.
3.
Insert three self-tapping screws in to the marked holes.
4.
Alternately turn the screws and gradually tighten them into the housing.
5.
Connect cable to the mains voltage supply. Make sure the power is turned off before
proceeding. Ensure proper insulation in the power socket.
Maintenance
Service:
It is recommended to check the connecting cable and the integrity of heater and ECD
housing. It should be checked for any sign of damage on housing or cable.
Attention
Before beginning maintenance work disconnect the heater and condensate drain from
power supply.
Electrical wiring
Please ensure that the installation is carried out according to the valid regulations
Brown: L - Phase
Blue: N - Neutral
Green/Yellow: PE – Protective earth
