OMEGA AIR B-DRY 1000, Инструкция по установке и эксплуатации, Страница: 17 / 65

17
5.1 Status Screen
To access the controller interface open the transparent cover on the controller housing. The
interface on the PLC block has four buttons and can display the information in four lines. To
move through the menu, press the up and down buttons. To enter a sub-menu or confirm an
action press right. To go back press left.
The first screen shows the system status. At the start-up of the dryer the controller is
initializing. This phase lasts a few seconds.
I N I T I A L I S I N G
When the B-DRY adsorption dryer is in the FIXED CYCLE MODE it is operating with fixed
adsorption-regeneration cycles.
When the B-DRY adsorption dryer is in the PDP VARIABLE CYCLE SAVING MODE it is operating
in a dew-point dependent energy saving mode with variable adsorption-regeneration cycles.
When the B-DRY adsorption dryer is in the STAND-BY mode the adsorption-regeneration
cycles are stopped for as long as there is a STAND-BY signal on
INPUT I1 (→for more
information see chapter 5.3).
A D S R E G
F I X E D M O D E
0 0 : 0 0 h
A D S R E G
V A R I A B L E M O D E
0 0 : 0 0 h