8
Installation TRIPLE
3.
At first, we must prepare studs to which we will later install the components on them. A stud
bolt (1) is necessary to screw into the nut (3) so a deep as is the outer diameter of the thread.
We need to prepare two pieces of studs.
4.
In the next step on the studs which was prepared in the previous step, we installed components
as shown below fig. When installing, we must be careful to turn all the filter housing in the same
direction of flow. The direction of flow is shown at the top of the filter head.
4
2
2
4
3
3
1
