Omcan WC-CN-0275-D, Инструкция по эксплуатации

Страница: 8 / 20

8
Operation
WINE CELLAR FEATURES AND USE
INITIAL SETUP
• Before connecting the wine cellar to the power source, let it stand upright for approximately 24 hours. This
will reduce the possibility of a malfunction in the cooling system from handling during transportation.
• Once you have plugged the unit into an electrical outlet, let the unit run for at least 60 minutes to acclimate
before making any adjustments.
TEMPERATURE ADJUSTMENT
• The wine cellar can be set to any temperature between 41° and 68°F to accommodate your wine storage
requirements. To set the temperature, press the button above the + or - icons to increase or decrease
the temperature setting until the desired temperature is attained. It may take some time to reach the set
temperature.
SHELVING (TYPE AND NUMBER OF SHELVES WILL VARY PER MODEL)
Your cabinet was designed to store a maximum number of bottles securely. We recommend that you observe
the tips below to optimize loading:
• Patented VinoView shelving (U.S. Design Patent# D826,995) proudly presents 6 of your favorite bottles
Installation
USE OF EXTENSION CORDS
• Avoid the use of an extension cord because of potential safety hazards under certain conditions. If it is
necessary to use an extension cord, use only a 3-wire extension cord that has a 3-blade grounding plug
and a 3-slot outlet that will accept the plug. The marked rating of the extension cord must be equal to or
greater than the electrical rating of the appliance.
REMOVING THE SHELF
To remove a rolling shelf:
1. Remove all bottles.
2. Pull the shelf out as far as it will go.
3. Lift the shelf up and off the slides.
INSTALLING THE HANDLE
1. Pull back the door seal behind handle location.
2. Insert screws into pre-drilled screw holes.
3. Attach gasket.
4. Attach handle.
5. Tighten screws and press door seal back into place.