7
INSTALLING THE HANDLE
Install the handle according to the following four steps:
1. Move door seal out in the place of installing the handle.
2. Take screws from manual bag and put it in the appointed place.
3. Fasten door handle by screw driver.
4.
Refit the door seal to the relevant position.
WOOD SHELF CHANGING
Once wood shelf needs to be changed, please check which kind of slider and which one is used.
If slider is (A), take out the shelf only and change another
new shelf - it will be okay. Please make sure the wood hole
needs to match the slider hook.
If slider is (B):
1. Unscrew the wood shelf from slider.
2. Take out the old wood shelf and change new one.
3. Screw the wood shelf again from shelf bottom as previous then it is okay.
(A)
(B)
during transit.
3.
After checking and there’s no problem, then please carry to the final place which should be taken cared as
follows:
a. Leaving space of minimum 5 cm between your wine cabinet and left and right wall; at least 8 cm
between back of cabinet and the wall.
b. Position the wine cabinet on a flat level surface; if not, adjust the feet of wine cabinet to keep level.
4. Away from sources of heat and high humidity areas (laundry room and bathroom, etc.)
5. Do not tilt it at an angle of more than 45°C / 113°F when moving the cabinet. Allow a minimum 10-minute
interval between transit and re-starting.
6. Make sure the ventilation is free if you wish to install your cabinet into a worktable; otherwise, it will reduce
the effect of usage.
7.
Please check the plug and cable before you connect the power.
Installation
