WEEKLY
1.
Turn main power saver switch to the OFF position. Disconnection unit from power source and allow to cool.
2.
Perform daily cleaning procedures.
3.
Using a damp cloth, wipe clean the fan guard located on the box cover under the unit.
CLEAN CONVEYOR BELT
4.
Reconnect power or turn power back on.
5.
Switch the ON/OFF switch to the ON position, and turn conveyor to its fastest setting.
6.
With the conveyor turned on and the crumb trays in place, take a wire grill brush or dry abrasive pad, clean the
exposed surface of conveyor belt by passing the brush or pad, back and forth across the surface of the conveyor belt as
the belt moves past. Continue until the entire belt is clean. Make sure the crumb tray is installed, this will minimize the
amount of particles that fall into the oven.
7.
When the conveyor belt is clean, take a damp cloth and wipe the onveyor, removing any loose particles on the belt
surface.
8.
Remove the crumb trays by sliding out from beneath the conveyor belt. Clean the crumb trays by wiping with a damp
cloth and mild detergent.
DO NOT USE CAUSTIC CLEANERS.
DO NOT RUN CONVEYOR OVEN WITHOUT CRUBM TRAYS INSTALLED.
OVERHEATING TO ELECTRICAL COMPONENTS AND PREMATURE FAILUURE CAN OCCURE.
DO NOT IMMERSE OR LET THE UNIT STAND IN WATER.
DO NOT HOSE DOWN THE UNIT OR THE TABLE/COUNTER IF THE UNIT IS ON THE TABLE/COUNTER.
KEEP AWAY FROM RUNNING WATER.
MOMTHLY
1.
Turn main power switch to the OFF position.
Disconnect unit from its power source and allow to cool.
2.
Perform daily & weekly cleaning procedures.
REMOVAL & CLEANING CONVEYOR BELT
3.
Heavily soiled conveyor surfaces, 214 models locate all 3 of the master links on the conveyor belt. Followthe step 1 in Fig 1, to remove
all of the master links. 210 models have no master links, to remove, unhook each end of one link and bring the two ends together, and
unthread. Once detached, re-hook ionto itself so not to get damaged.
4.
Now that the liks have been unhooked, the conveyor can now be carefully removed from the oven. Syanding at one end of the oven.
Starting with the end on the bottom, roll the conveyor belt until it has been totally removed. Take careful notice being sure not to damage
the heater tubes, and working it over the drive sprockets, ( see Figure 2.).
5.
Clean conveyor belt in deep sink, caustic cleaners may be used. For a heavy soiled conveyor belt, soak over night in hot soapy water.
NOTE: DO NOT ATTEMPT TO CLEAN THE HEATER TUBES.
2.