Omcan Santos 55, Инструкция по эксплуатации

Страница: 11 / 24

11
CLEANING
IMPORTANT:
• In all circumstances, the machine should be stopped and the machine’s power supply cable (10)
unplugged.
• Do not clean with a water spray or pressure jet.
MAINTENANCE
Before carrying out any work on the machine, it must be unplugged from the mains and the motor start
capacitor discharged.
DISCHARGING THE CAPACITOR
• Unscrew the 2 screws located under the machine in the middle of the base plate (fig. E).
• Pull the electrical components unit (26) out of the base plate.
• Using a screwdriver with an insulated handle, touch the 2 capacitor connections (14). You should see an
electric arc which means that the capacitor has been discharged.
SPARE PARTS
This machine requires no specific maintenance. The bearings are lubricated for life.
If work is required to replace worn parts such as the grindstones or the electric or other components, refer to
the parts list (see exploded view at the end of the manual).
For all spare part orders (see references in the exploded view at the end of the manual), state:
• The type.
• The machine serial number.
• The electrical specifications (16) recorded under the machine.
REPLACING THE GRINDSTONES
IMPORTANT: always replace both 2 grindstones (9) at the same time. Use Omcan grindstones. Please refer to
the specifications table of the machine to order the reference of the set of grindstones to match your machine.
The 2 grindstones are identical and can be fitted equally either on the moving plate (8) (moving grindstone) or
on the adjusting nut (5) (fixed grindstone) (fig. F).
1. Close the bean shutter (6) (fig. G).
2. Run the machine until the coffee beans waiting in the grinder body have passed through.
3. Stop the machine and unplug the mains power lead (10).
4. Take off the bean container (2).
5. With one hand, press the indexing pointer (7) and with the other unscrew the adjustment nut by turning it in
an anti-clockwise direction (fig. I). Care: When this part is fully unscrewed, handle it with care so as not to
damage the brass thread.
6. Unscrew the three screws of each grinder (fig. J). For blocking the rotation of grinder holding plate while
unscrewing or screwing the fastening screws of movable grinder, place a screwdriver, non aggressive,
between the grinding body and one of the fins of the plate.
Maintenance