8
Troubleshooting
Maintenance
If machine will not start:
•
Check: the mains power supply and the condition of the power supply cord.
•
Check that the On/Off lamp (6) lights up when the switch is at position "1-On". If it does not, replace the
switch.
• With the switch on position "0-Off", check that the cone (2) can be easily rotated by hand.
○ If the cone does rotate, have the capacitor and the motor checked by a person qualified to do so.
○ If the cone does not rotate, have the clutch checked.
The appliance stops after the motor has overheated: (the motor unit is hot).
The motor is protected by an integrated thermal cut-out system. If it overheats the motor stops.
• Put the On / Off switch (6) to the "0-Off", position and unplug the machine.
• Wait for the motor to cool down (25 to 45 minutes) then press the On / Off switch (6) ("1-On" position).
If the problem persists, switch off the power supply to the machine (unplug the cord from the mains socket) and
call in the maintenance service or contact a Omcan approved dealer.
The appliance stops following an overload:
•
If the motor stalls during operation, release the pressure on the lever to allow it to start again.
If the problem persists, switch off the power supply to the machine (unplug the cord from the mains socket) and
call in the maintenance service or contact a Omcan approved dealer.
The motor operates but the cone does not rotate:
•
Check the condition of the cone (2) drive pin (9) (Fig. D).
•
Check that the clutch operates correctly (Fig. E):
○ Start the appliance, with the switch at position "1-On".
Spare parts:
IMPORTANT:
Use of spare parts other than certified original Omcan parts is prohibited.
This machine requires no specific maintenance. The bearings are lubricated for life. If any intervention is
necessary to replace parts subject to wear, such as the cone, the pressing cup electrical or other components,
please refer to the parts lists (see the exploded view at the end of this manual).
For all spare part orders (see references in the exploded view at the end of the manual), state:
•
The type.
•
The machine serial number.
• The electrical specifications recorded under the machine.
