7
Maintenance
Operation
USING FOR THE FIRST TIME:
Take care: The fruit used must be washed carefully before squeezing.
Preparation and use:
1.
Cut the citrus fruit into two halves ready for squeezing.
2.
Place the On/Off switch (6) at On. In this position the electric motor operates but the cone (2) is not rotated.
3.
Position the half-orange on the cone (2).
4.
Apply increasing pressure to the lever (1) for about 5 seconds. In this position, it is the pressure on the
lever that (1) engages the clutch for the cone (2).
5.
Release then lift the lever (1) and remove the orange skin from the cone.
6.
Proceed in the same fashion for all the half-oranges to be squeezed.
7. Take care: When you have finished using the citrus fruit squeezer, stop it using the On/Off switch (6).
CLEANING
IMPORTANT:
•
Stop the appliance and unplug the power supply cable.
•
The appliance should neither be cleaned in a jet of water nor with a high pressure spray.
• The motor unit (7) must not be immersed in water.
You are advised to clean the appliance as soon as it has finished being used.
It will be easier to clean if you do not allow the remaining scraps of food to dry.
1. Remove the cone (2) and rinse it under running water.
2.
Rinse the juice container (5) with water, that can be collected in a glass placed on the glass-holder (8).
- Model n°70: Remove the juice container (5) by hand.
3. Finish off cleaning the container with a sponge.
4. Clean the pressing cup (3) with a sponge.
- Model n°70: removing the pressing cup by rotating ¼ turn.
5. Remove the glass-holder (8), the grid (10) and rinse under running water.
6.
Model n°10: When more thorough cleaning is required, the pressing cup (3) must be removed. To do this,
unscrew it by turning it anti-clockwise (Fig. B and Fig. C).
The base and the motor unit trim should be cleaned with a soft, damp sponge and then dried.
MAINTENANCE
Prior to carrying out any intervention on the appliance, it must be disconnected from the mains without fail.
