6
Installation
to always carry, store and handle the unit in a vertical position and follow the instructions found on the
packaging.
2. If the unit was accidentally or purposely placed in a non-vertical position during transport, before operating
the unit, keep the unit in a vertical position for approximately 24 hours, to allow the oil to flow back into the
compressor.
UNPACKING
Remove the wooden case board and plastic covering. Make sure that the unit has not been damaged. Remove
the plastic film from all the stainless steel panels if applicable.
IMPORTANT: The packaging should be kept away from children as it is potentially dangerous. Dispose
of the packaging according to the regulations from the local authorities.
POSITIONING
1. Never clean the unit with pressurized water jets.
2.
Place the unit on a flat and stable surface.
3. Install the unit in a location where it can be overseen by trained personnel.
4. For good ventilation, keep a distance of 20 cm (7 inches) between unit and walls or other objects. Increase
the distance if the objects are a heating source. When the dispenser is in place, press the brake on the
wheels in order to keep it from moving.
ASSEMBLY
1. Remove the bottom pallet from the unit.
2. Fix the shelves on the unit.
ELECTRICAL CONNECTION
Before inserting the plug into the electrical socket, carefully read the following precautions:
1. Make sure that the unit is properly connected to an properly grounded outlet, in compliance with current
safety standards.
2. Make sure that the voltage is in accordance with what is indicated on the rating label.
3.
The current available is sufficient for the maximum required by the unit.
4. If necessary, use multiple outlets which are properly grounded, in compliance with current safety standards.
If in doubt, only consult qualified technicians.
THE REFRIGERATED SHOW CASE MUST BE CONNECTED TO AN ELECTRICAL SOCKET WITH A
GROUND.
