8
Operation
the special Inox roller (A1) or with the hands.
6.
To roll out the pasta and obtain a pasta sheet turn the regulator (P) anti-clockwise to reduce the distance
between the drawing rollers; leave the Inox roller (A1) in the lowered position and insert the sheet obtained
between the Inox roller (A1). Repeat this operation until the sheet is of the required thickness.
TO DISMANTLE THE MACHINE:
turn the master switch to position “0”, remove the plug from the socket,
release the pasta hopper (A) from the supports (C1).
AFTER USE:
follow the instructions described in the Maintenance section.
GENERAL WARNING
Remember that the safety device prevents the machine from operating when the roller (A1) is not lowered.
USING THE SIMPLEX CUTTING AND ROLL ACCESSORY (FIG. 3, 4, 5)
BEFORE USE:
follow the instructions in the Maintenance section.
1.
Place the machine on a suitable surface.
2. Insert the supplied pin (F) in the pasta hopper (B).
3.
Insert the pasta hopper (B) in the special seat (G1).
4.
Turn the taglia-sfoglia (B) clockwise until it is completely fixed (Fig. 4).
5.
Fit the pasta hopper (A) on to the supports (C1) with the Inox roller (A1) positioned downwards.
6.
Plug in the machine and turn the master switch to position “I”. The machine will start moving so that the
transmission arm (F) can be inserted.
7.
Push the ready prepared sheet of pasta through the cutting rollers.
TO DISMANTLE THE MACHINE:
turn the master switch to position “0”, remove the plug from the socket.
Rotate the pasta hopper accessory counterclockwise; remove the same accessory and then remove the pin.
AFTER USE:
follow the instructions described in the Maintenance section.
GENERAL WARNING
Remember that the safety device prevents the machine from operating when the roller (A1) is not lowered.
USE OF THE MANUAL SIMPLEX CUTTING AND ROLL ACCESSORY (FIG. 7)
BEFORE USE:
follow the instructions in the Maintenance section.
1.
Place the machine on a suitable surface.
2. Fit the roll and cut accessory (B) on to the supports (C2).
3.
Fit the handle (M) into the appropriate hole and proceed with the manual working of the pre-prepared sheet
of pasta.
TO DISMANTLE THE MACHINE:
remove the handle (M) and release the roll and cut accessory (B) from the
supports (C2).
