Omcan PM-IT-0012E, Инструкция по эксплуатации

Страница: 8 / 24

8
Operation
Installation
This machine kneads the different products desired and enables you to obtain different kinds of noodles with
a different group of lengths because it draws the dough, thanks to different discs. This action is carried out
thanks to a mixer linked to an Archimedean screw which obliges the product to assume the desired shape
going through a drawplate.
CUTTING UNIT ASSEMBLY
Remove the components in the tank. Assemble the cutting unit, after removing the socket-head screw from the
bearing. Then tighten the screws right down again. Plug the unit into the power supply socket of the machine;
let the safety coupling click in.
CONNECTION TO THE WATER SYSTEM
For machines supplied with an extrusion sleeve cooling system, connect the machine to the water system,
install the sending tube, (when it is non-existant: use a tap, possibly with screw-control) to the outer part
of the machine, in order to regulate the water flow. The exit-flow tube must allow free water discharge. We
recommend that the water pressure inside the machine, does not exceed the 1.0 - 1.5 bar. To connect the
external parts, use a flexible tube with an inside diameter of 13 mm, safely fixed by a metal band with a screw
that can be closed with a screw-driver or key.
CONTROL OF THE INSTALLATION
Every operation is voluntarily commanded by means of the start button with the tank safety lid closed
by means of the double safety device.
Turn the selector to the knead position and check:
• Make sure that the mixer is rotating counter-clockwise, facing the front of the machine, when the switch is
placed on the “mix” position , (the Archimedean screw also turns counter-clockwise). In the “0” position
all of the machine’s elements should be still; in the drawplate position , the mixer turns clockwise, the
Archimedean screw should turn the same way (check from the lid slits).
• Check the efficiency of the double safety device on the lid. The device sets off two micro-switches; one is
controlled by the lid hook, inside the stop slot; and the other from the lid itself. To check this, make sure that
microswitch in the slot begins to be enabled when the hook has not yet gone out of the slot itself. The lid
microswitch must be heard to click when the lid is lifted approx. 10 - 15 mm.
• Operation of the buttons and pilot lamps according to the signs given.
• The knife in its working position should be turning clockwise.
• The correct connection of the water cooling system, should include checking for eventual water leaks.
If the machine or some of its parts breakdown, call your local authorised dealer or concessionaire for
repairs.