9
Installation
• At any rate, with average dough, after 3 - 5 minutes, check the external temperature of the ring nut and if it
seems too high, gradually open the regulating valve. Frequently check the temperature and regulate water
flow, tending to keep temperature constant.
NOTE:
If the product is kneaded at an excessive temperature, it tends to change colour and/or blanch slightly.
VARIANT FOR MODEL PM-IT-0040
The model PM-IT-0040 uses the second tank (Figure 14B) to enable dough to be kneaded (press button
A - Figure 13) simultaneously with the worm screw extrusion stage. This allows output to be increased
considerably. Knead the dough as seen for the main tank and then pour it in by turning the tank by means of
the device provided (button B - Figure 13).
• To do this, first lift the lid of the bottom tank (Figure 14A) even if this causes the machine to stop. The
new product must have the same consistency as the previous contents of the tank so as to achieve a
homogeneous dough mixture.
DANGER:
While the tank is lowered, make sure the area near the lift (Figure 15A) is vacated as the control
protection guard (Figure 15B) may be dangerous in the final stage of the movement (squeezing or cutting
dangers).
After the operation:
• Stop the machine by switching the selector (Figure 16A) as well as the others to the “0” position.
• Rotate the cutting group to the stop position (Figure 17).
• Turn the selector (Figure 16B) to the knead position
for 10-15 seconds in order to eliminate the
pressure on the die caused by the product.
• Return the switch to “0.”
• Disassemble and wash the movable parts (Figures 18 - 19) and clean the machine (see Maintenance
section).
• Close the water tap, for machines fitted with a cooled extrusion sleeve.
Operation
PREPARING THE MACHINE
Prepare the machine before every process cycle. BE SURE that the machine, especially parts which come
in contact with food products (extrusion sleeve, Archimedean screw, pool, mixer, drawplate and knife) are
perfectly clean (see Maintenance section).
NOTE:
Always clean with machine off.
OPERATING PRINCIPLE
This machine kneads the different products desired and enables you to obtain different kinds of noodles with
a different group of lengths because it draws the dough, thanks to different discs. This action is carried out
thanks to a mixer linked to an Archimedean screw which obliges the product to assume the desired shape
Содержание PM-IT-0008
