Omcan PH-CN-2210-S, Инструкция по эксплуатации

Страница: 9 / 20

9
ASSEMBLY INSTRUCTIONS
WARNING: Remove protective cover before assembling.
1. Turn the base upside down, then attach wheel assembly (I) to base (H) using 2pcs M8 flange nuts (AA)
and 2pcs bolts M8x16 (BB). Attach 3pcs anchoring arm (MM) to base (H) using 6pcs M6 nuts (OO) and
6pcs bolt M6x10 (NN). Be sure that the wheel assembly is parallel to the base. Tighten bolts securely.
2. Attach 3 pcs support brackets (G) to base (H) using 3 pcs bolts M8x16 (BB).
3. Attach post assembly to support brackets (G) using 6pcs bolts M6 X 30 (EE) and 6pcs M6 flange nuts
(CC). Tighten bolts securely.
4. Load tank housing onto post, slide tank housing down.
5. Remove the 4 pcs preassembled stainless steel bolts (DD) from the burner assembly (C). Insert the gas
hose from the top end of the post (E), then attach the burner assembly (C) to post (E) using the four bolts
removed at the beginning of this step. Tighten bolts securely.
6. Attach 3 pcs reflector panels (A) to center reflector (B) using 9 pcs Screws M6x10 (II) and 9 pcs cap nuts
(JJ). Fully tighten all of the screws.
7. Attach 3 pcs reflector spacers (FF) and 3 pcs washers (GG) to burner assembly (C) first. Tighten the
reflector spacers. Slide 3pcs washers (GG) over threaded end of spacer. Attach the reflector assembly to
the top of reflector spacer (FF) using 3 pcs washers (GG) and 3 pcs wing nuts (KK).
8. Place the propane gas tank (not included) on the base.
9. Turn the cylinder valve on the tank clockwise to close the propane tank. Attach the regulator to the cylinder
valve by turning the regulator coupling nut clockwise. Make sure it is fastened securely and tighten
connections by hand only.
Installation