12
Operation
replace the hose (if applicable).
TO LIGHT
1. Turn on the valve on the gas supply cylinder.
2.
Press and turn the variable control knob to the ‘HI’ position.
3.
Press down the variable control knob and hold for 3-5 seconds.
4.
While holding down the variable control knob, press the igniter button several times until the burner head
fame ignites. Release the variable control knob 30 seconds after the ignition.
5.
If a new tank has just been connected, allow at least one minute or more for the air in the gas pipeline to
purge out.
6. The flame can be watched and checked from the viewing hole located on the base of the burner.
7. Turn the variable control knob to the ‘LO’ position for 5 minutes or more before turning the knob to desired
temperature setting. If a small flame is needed, turn the variable control knob to the ‘LO’ position.
8. If the burner flame goes out accidentally or it is blown out by wind, turn off the heater and wait at least 5
minutes or more to let the gas dissipate before lighting again to avoid possible gas explosion. Repeat steps
2 through 4.
When lit for the first time the heater may emit a slight odor and smoke. This is a normal and temporary
condition. Emitter screen will become a bright red due to the heat. The color is more visible at night. Flame
patters should be a blue flame; these flames should not be yellow in color; indicating an obstruction of airflow
through the burners.
TO EXTINGUISH
1.
Turn control knob clockwise to the “off” position.
2.
Close the cylinder valve on the propane gas tank if you don’t intend to use it for a long time.
Maintenance
•
Before performing any maintenance always disconnect propane gas tank.
•
Keep the heating item free and clear from combustible materials.
•
Visually inspect burner for obstructions and keep tank enclosure free and clear from debris.
•
Use a soft brush to get rid of the mild stains, loose dirt and soil after the burner is completely cooled down.
Wipe down with a soft cloth.
• Harsh weather conditions may cause stubborn stains, discoloration and possibly rust pitting.
•
Permanent damage may occur if powder or solvent comes in contact with painted or plastic components on
this heating unit.
•
Keep the heating unit stored away from direct sunlight.
•
If storing this unit inside, disconnect the propane gas tank from the gas valve.
• Not using manufacturer approved or supplied parts/accessories may result in a defective condition and void
the warranty of this heating unit.
Содержание PH-CN-2210-S
Страница 10: ...10 Installation...
Страница 15: ...15 Parts Breakdown Model PH CN 2210 S 47595...
Страница 16: ...16 Parts Breakdown Model PH CN 2210 S 47595...