Omcan MS-IT-0370-H, Инструкция по эксплуатации

Страница: 9 / 28

9
Maintenance
SHARPENING OPERATION
DANGER
The sharpening operation must be performed during the manual functioning.
For a correct sharpening of the blade follow these instructions:
1. Clean the blade removing any greasy residue.
2. Make sure that the machine is off.
3. Rotate the slice thickness control to zero to make sure that the blade is covered by the slice thickness
plate.
IMPORTANT
During the following operations the blade must always be covered by the removable protection.
4. Lift the sharpener cover.
5. Slip off completely the sharpener and spin it 180 degrees.
6. Replace the sharpener device.
7. Push the push button blade start to start the machine.
8. Sharpening: Press the sharpening wheel for about 10-15 seconds.
Then press simultaneously also the grinding stone for two seconds.
Contemporaneously loosen the two grind stones.
The sharpening and honing take place then simultaneously.
ATTENTION: for a suitable effect please execute sharpening for 10-15 seconds approx.
9. After sharpening press the blade stop push button.
10. Lift and rotate 180 degrees the sharpener and reallocate it into its initial position. Loosen the handle
rotating it clockwise to block the sharpener. Lower the sharpener cover.
CLEANING OF THE GRINDING WHEELS
To obtain an excellent sharpening the grinding wheel must always be clean. Remove dirt and grease with
alcohol and the supplied special brush. Be sure to clean and sanitize the blade after sharpening.
MAINTENANCE
All cleaning and maintenance operations must only be carried out with the machine disconnected and isolated
from the mains supply and the slice thickness control on zero.
CONTROL OF THE AIR GRATING
An air grating for the motors ventilation is placed in the lower side of the machine. Keep the section-holes free
and clean them with a brush at regular intervals.