Omcan MS-IT-0330-C, Инструкция по эксплуатации

Страница: 9 / 24

9
Maintenance
COMPONENTS REMOVAL
DANGER: During the cleaning operations be careful: danger of accident.
PRODUCT HOLDER
1. Position on zero the slice thickness control.
2. Loosen up completely the product holder clamping handle rotating it counterclockwise.
3. Pull the product holder towards the operator to block it. The metallic click means that the product holder is
clamped.
4. Lift the pusher from the guide bar.
5. Lift the product holder slipping it off from its support.
6. Clean the product holder.
IMPORTANT: The slice thickness control is clamped on zero.
SLICE DEFLECTOR
1. Loosen the fixing screws and remove the slice deflector.
BLADE COVER
1. Loosen the blade cover fastener handle rotating it counterclockwise.
2. Push the handle in the direction of the blade.
3. Lift the blade cover.
ATTENTION: Once removed the blade cover, an interlocking device stops the rotation of the blade.
BLADE CLEANING
DANGER: During the cleaning of the blade, be careful of any accidental contact with the blade.
1. Mop up the front side of the blade with a dampen cloth and move slowly from the centre to the edge of the
blade, as shown by the arrow in the picture.
2. Clean in the same way the back side of the blade.
3. Dry with a cloth both sides of the blade.
4. After cleaning, fix the blade cover.
5. Insert the fastener and screw to block the blade cover.
Clean all the pieces in warm water and washing-up liquid. Rinse them with hot water and dry them. Assemble
the machine following in reverse the procedure described above.
GUIDES LUBRICATION
This operation must be performed after cleaning the slicer or whenever the sliding is difficult. Use oil SHELL
ONDINA 15 or ESSO MARCOL 82.