Omcan MS-IT-0330-C, Инструкция по эксплуатации

Страница: 7 / 24

7
Operation
Maintenance
HOW TO LOAD THE PRODUCT TO CUT
1. Place the product to cut against the product holder and the thickness plate sides.
2. Lay the last slice device on the product to cut, far from the slice thickness plate. The product is fed to the
slice thickness plate by gravity, this makes the cut easier.
3. Rotate the slice thickness control onto the cutting thickness you wish.
4. Press the green pushbutton to start the blade.
5. At constant speed feed the product holder to the blade stroke end then return to the operator and repeat
the operation.
6. When the work is over, pull the product holder towards the operator, press the red button to turn the blade
off and rotate the slice thickness control on zero.
HOW TO LOAD SHORT PRODUCTS (LAST SLICE)
Check that the slicer is off and position the slice thickness control on zero.
WARNING: Do not use your hands to push the products towards the blade.
1. Place the product to be cut against the wall of the product holder and the slice thickness plate.
2. Push the goods against the slice thickness plate using the last slice device.
3. Rotate the slice thickness control onto the cutting thickness you wish.
4. Press the green pushbutton to start the blade.
5. At constant speed feed the product holder to the blade stroke end then return to the operator and repeat
the operation.
6. When the work is over, pull the product holder towards the operator, press the red button to turn the blade
off and rotate the slice thickness control on zero.
BLADE SHARPENING
Whenever the cut is not satisfactory, sharp the blade. The time interval between a sharpening and the following
depends on the intensity of use of the slicer and on the kind of food you cut. Replace the blade when the
diameter becomes 10 mm less than the nominal diameter. For the replacement, ask the assistant service
closest to you.
WARNING
The replacement of the blade is dangerous operation. Should the sharpening quality be not satisfactory,
replace the stones. Contact a customer servicing.
1. Clean the blade removing any greasy residue.
2. Make sure that the machine is off.