Omcan MS-IN-0250H-R, Инструкция по эксплуатации

Страница: 9 / 24

9
Maintenance
table, the product holder and the blade.
CLEANING THE BLADE
Press a damp cloth on the surface of the blade and move it slowly from the centre toward the outside, as
shown in the figure (Fig. D), on the blade cover side and the opposite side. In the same way, dry it using a dry
cloth.
CLEANING THE MACHINE BODY
Clean the machine body with a damp cloth or a sponge, rinsing with water. Dry carefully.
ASSEMBLE THE BLADE COVER
• Replace the blade cover as in the figure.
• Rotate the blade cover 90° clockwise until it locks into its initial position (Fig. E).
ASSEMBLE THE MEAT TABLE
Lift the meat table and move it to the cutting position, pressing down lightly until it clicks.
BLADE MAINTENANCE
Cleanse the blade regularly to keep it sharp and functional. Do not wash the blade in the dishwasher.
BLADE EXTRACTION
Extract the blade and clean the inside. Handle the blade with great care and always use the specific extractor.
Remove the blade cover from the machine and apply the blade extractor following the steps below:
• Align the three pins of the blade extractor with the three holes of the blade-locking ring (Fig. F).
• Screw the two knobs into the threaded holes on the blade (Fig. G).
• Turn the blade extractor knob counterclockwise while holding one of the two knobs (Fig. H).
• Remove the blade using the extractor two knobs (Fig. I)
Insert the blade proceeding as follows:
• Insert the blade on the pulley using the blade extractor (Fig. J).
• Turn the blade extractor knob clockwise while holding one of the two extractor knobs (Fig. K).
• Unscrew the two knobs and remove the blade extractor (Fig. L).
WARNING: The blade is very sharp, like a knife. For any cleaning and maintenance operation that
involves dismantling of the blade, make sure to pay extra attention to keep hands far away from the
edge of the blade itself. Always use protective, cut resistant gloves. To remove the blade, always use
the specific blade extractor as indicated in this instruction manual. Always hold the blade by the blade
extractor only. Make sure nobody gets close to the blade when extracted.
SHARPENING
SAFETY
For your safety, we recommend that you carefully read the instructions in the machine Operating manual
before using the sharpener.