Omcan MM-IT-0080, Инструкция по эксплуатации

Страница: 9 / 20

9
Operation
- Signals that the machine is connected to the electrical network.
5. Drive indicator light.
- Signals that the tool of the machine is in movement.
- Located close to the start push-button “3” and close to the reverse drive push-button “3”.
- Visible only when the control is operating.
TURNING THE APPLIANCE ON AND OFF
CHECKING CONNECTION TO ELECTRICITY SUPPLY
Switch the on/off switch on the appliance to position “I”. The green light “2”
should come on, indicating power on. Press push button “3” for starting, the
red indicator light “5” should come on, and then immediately press push button
“1” for stopping. This is to check that the appliance works correctly. Press push
button “4” for starting, the red indicator light “6” should come on, and then
immediately press push button “1” for stopping. This is to check that the rotor
rotates in an opposite direction to push button “3”.
CHECKING PROTECTIONS AND SAFETY FEATURES AND THEIR EFFICIENCY
1. Rotor Protection grille.
Visually check that the protection grille is intact.
2. Micro-switch.
With the appliance running, check that it automatically stops when the protection grille is raised. If this is
not the case contact you local authorised dealer or the manufacturer.
ATTENTION!
If the previously mentioned safety protections and casing are not intact, are damaged, missing or work
incorrectly, turn the appliance off and contact the aftersales assistance to repair the appliance.
TURNING ON THE APPLIANCE
Switch the power on/off switch from position “0” to “1”. Indicator “2” should light up indicating power on. Press
push button “3” for starting the rotor.
TURNING OFF THE APPLIANCE
To stop the appliance press push button “1” (stops the electric motor), the red indicator light “5” will go out.
Indicator light “2” will remain on indicating power on. Switch the power on/off switch to position “0” turning off
the power supply.
INVERSION
To invert rotor rotation press push button “4”.
Note: When a work shift is over always switch the on/off power switch to position “0”.