Omcan BS-BR-3150-SS, Инструкция по эксплуатации

Страница: 6 / 28

6
Safety and Warranty
WARNINGS
• The operator has to be well familiar with the position of ON/OFF Switch to make sure the Switch is easy to
be reached when necessary.
• Before any kind of maintenance, physically remove plug from the socket.
• Provide space for a comfortable operation thus avoiding accidents.
• Water or oil spilled on the floor will become a slip hazard. Make sure the floor is clean and dry.
• Before using any commands (switch, buttons, lever), be sure it is the correct one. In case of doubt, consult
this manual.
• Never touch any manual commands (switch, buttons, lever) unadvisedly.
• If any work is to be made by two or more persons, coordination signs will have to be given for each
operation step. Every step of the operation shall be taken only if a sign has been made and responded.
ADVICE
• In case of power shortage, immediately switch the machine off.
• Use recommended or equivalent lubricants, oils or greases.
• Avoid mechanical shocks, once they may cause damages or bad functioning.
• Avoid water, dirt or dust contact to the mechanical and electrical components of the machine.
• DO NOT change the standard characteristics of the machine.
• DO NOT remove, tear off or damage any safety or identification labels stuck on the machine. If any labels
have been removed or are no longer legible, contact your nearest dealer for replacement.
SAFETY PROCEDURES AND NOTES BEFORE SWITCHING THE MACHINE ON
IMPORTANT: Carefully read ALL INSTRUCTIONS of this manual before turning the machine ON. Be sure to
fully understand all the information contained in this manual. If you have any question contact your supervisor
or your nearest Dealer.
DANGER
An electric cable or electric wire with damaged jacket or bad insulation might cause electrical shocks as well as
electrical leak. Before use, check the conditions of all wires and cables.
ADVICE
Be sure to fully understand all the information contained in this manual. Every operation function or procedure
has to be thoroughly clear. Before using any commands (switch, buttons, lever), be sure it is the correct one. In
case of doubt, consult this manual.
PRECAUTIONS
The electric cable has to be compatible with the power required by the machine. Cables touching the floor or
close to the machine need to be protected against short circuits. The oil reservoirs have to be filled until the
indicated level. Check and refill if necessary.
ROUTINE INSPECTION
ADVICE
When checking the tension of the belts or chains, DO NOT insert your fingers between the belts and the