Omcan BE-IT-0406, Инструкция по эксплуатации

Страница: 7 / 20

7
Installation
• The water sources must be at a safe distance.
• Ventilation and lighting must be suitable and comply with the hygiene and safety standards foreseen by the
existing laws.
INSTALLATION PROCEDURES
The machine is supplied in closed packaging. After having removed the polystyrene protection and the
machine from the pack, proceed as follows:
• Position the machine in the place set aside for it.
• Remove the protective film (F) without using tools that could damage the surfaces.
• Cut the two straps A-B that are locking the rod and balancing device (Fig. 1).
Mount the top chute and the two protections (Fig. 2) proceeding in the following way:
• Position the chute so the holes A - B - C match perfectly with the spacers A - B - C and then press by the
chute holes until it clicks into place.
• Remove screws F - G - D - E, position the top protection so the holes F - G match perfectly with those
underneath; now tighten the screws to lock the protection. Proceed in exactly the same way for the fixings
D - E of the bottom protection.
POSITIONING THE MACHINE
The surface, on which it stands, must be horizontal. Leave no obstacles of any kind in its immediate vicinity
that could hinder its normal ventilation. The electrical outlet must be easy to access, no moving should be
necessary.
The distance between the appliance and the outlet must be such that the power cable is not stretched taut and
it must never be under the appliance’s supporting feet.
AREA NEEDED BY THE OPERATOR
Under normal operating conditions and for the optimum exploitation of all the appliance’s potential, the operator
needs the area illustrated in the figure below.
ELECTRICAL CONNECTION
• To connect the appliance to the electricity mains, use a power cable with plug.
• The electricity mains must be fitted with an automatic RCD with characteristics suitable for those of the
machine and where the distance between the contacts must be at least 3 mm. An effective earthing system
is of paramount important.
• Check that the supply voltage and frequency of the system are compatible with the values specified in the
Technical Specifications and on the plate on the back of the machine.