Omcan 46724, Инструкция по эксплуатации, Страница: 8 / 20

8
Installation
OVEN POSITIONING
Ensure that the oven is put on a stand with the suitable carrying capacity and that it is flat. After unpacking the
oven from its packing, position it in prepared location, taking into account the minimum distances. Remove
possible protections in polystyrene and take off the protecting film (F) avoid use of tools which can damage the
surfaces.
EQUIPMENT HOOK-UP
Electrical connection
The oven is not provided with a power supply cable. When connecting the appliance electrically, an automatic
RCD must be interposed with an opening distance between contacts of at least 0.1” / 3 mm. To connect the
appliance electrically it is essential to proceed in the following way:
• Raise the cover of the oven.
• Connect to the terminal block the power cable.
The power supply cable must be of H07-RNF type, with approved minimum cross section as prescribed by the
specific directive.
The electrical outlet must be easy to access, no moving should be necessary.
The electrical connection (plug) must be easily accessible, also following oven installation.
The distance between the machine and the socket must be adequate to not cause tension in the power supply
cable. In addition, the cable must not be located beneath the machine support base.
If the electrical power supply cable is damaged, it must be replaced by the technical
assistance service or by a qualified technician to prevent any risks.
Ground connection
It is mandatory that the electrical system is equipped with a ground connection. The
appliance must be part of an equipotential system. The connection is done on terminal
marked with symbol which you will find near the cable clamp. The equipotential symbol is
showed in the following figure.