Omcan 46204, Инструкция по эксплуатации

Страница: 15 / 20

15
Troubleshooting
The worm turns slowly and/or
without force.
The voltage of the power source
is lower than that required by the
machine.
Make sure that the power source
voltage is adequate for the
machine.
The mincer/grinder makes strange
noises.
The worm is jammed by a foreign
object.
Dismantle the worm/cutting set
assembly following the instructions
in this manual and remove the
foreign object that is jamming the
worm.
Possible aberrations in the gears,
motor- reducer, or the reducer
bearings.
Have the distributor check the
condition of the gears, reducer,
motor, and reducer bearings.
Oil stains present on the lower part
of the machine.
The gear reducer is leaking oil. Notify your distributor’s technical
service department.
Warning! ALWAYS power off and unplug the machine when resolving any problem. In the event your
technician is unable to resolve the difficulty, DO NOT CONTINUE TO USE THE MACHINE and contact
your authorized Omcan dealer for service.