7
Installation
OPTIONAL SNEEZE GUARD ASSEMBLY
Please review the parts list above and ensure that you have all the parts necessary to complete assembly.
Should you have any difficulty assembling your cover, please call our customer service line at 1-800-465-0234,
or email us at [email protected].
1.
Remove the four screws, two on each side, from the top inner area of the hot dog roller. See figure 1.
2.
Place the back side glass mount (C) onto the machine and reinsert the screw. Do not tighten down the
screw at this time because we may need to move it forward of back in a later step. See figure 2.
3.
Repeat step two for the other side rear glass mount (F) and the two front glass mounts (D&G). Remember
not to tighten down the screws just yet. See figure 3.
4.
Place one of the glass side panels (A) into one set of glass mounts. The mounts may need to be moved
forward or back to get a snug fit. Once the fit is snug you may tighten down the screws to hold the glass
securely. Repeat for the other side. See figure 4
5.
Slide the curved top glass (B) into the rear side glass mounts and push all the way down. See figure 5.
Ensure the edge of the curved top glass and the edge of the side glass are flush. See figure 6. If the glass
seems too snug you may need to loosen one of the screws holding the rear side glass mounts. Once the
top glass is in place, tighten the screw back down again.
6.
Set the front stainless trim rail (E) onto the edge of the top glass. Ensure that the holes in the ends of the
trim rail line up with the holes in the top corners of the side glass (A). See figure 7.
7.
Finally, secure the front stainless trim rail to the side glass with the nuts and bolts (H). See figure 8.
NOTE: Be sure to NOT over tighten the nuts and bolts, as this might crack the glass.
