Omcan 44532, Инструкция по эксплуатации, Страница: 7 / 24

7
Safety and Warranty
SAFETY PROCEDURES AND NOTES BEFORE SWITCHING THE MACHINE ON
IMPORTANT
Carefully read ALL INSTRUCTIONS of this manual before turning the machine ON. Be sure to well understand
all the information contained in this manual. If you have any questions contact your supervisor or your nearest
Dealer.
DANGER
An electric cable or electric wire with damaged jacket or bad insulation might cause electrical shocks as well as
electrical leak. Before use, check the conditions of all wires and cables.
ADVICE
Be sure to well understand all the information contained in this manual. Every operation function or procedure
has to be thoroughly clear. Before using any commands (switch, buttons, lever), be sure it is the correct one. In
case of doubt, consult this manual.
PRECAUTIONS
The electric cable has to be compatible with the power required by the machine. Cables touching the floor or
close to the machine need to be protected against short circuits. The oil reservoirs have to be filled until the
indicated level. Check and refill if necessary.
OBSERVATION
For your own safety read all the machine stickers.
ROUTINE INSPECTION
ADVICE
When checking the tension of the belts or chains, DO NOT insert your fingers between the belts and the
pulleys and nor between the chain and the gears.
PRECAUTIONS
Check the motor and sliding or turning parts of the machine in case of abnormal noises. Check the tension
of the belts and chains and replace the set when belts or chains show signs of wearing. When checking the
tension of belts or chains DO NOT insert your fingers between belts and pulleys, nor between the chains and
gears. Check protections and safety devices to make sure they are working properly.
OPERATION
WARNINGS
Do not use the machine with long hair that could touch any part of the machine. This might lead to a serious
accident. Tie your hair up well and/or cover it with a scarf. Only trained or skilled personnel shall operate this
machine. Never touch turning parts with your hands or any other way, NEVER operate the machine without
any original safety devices under perfect conditions.