Omcan 20236, 20237, Инструкция по эксплуатации

Страница: 12 / 28

12
Maintenance
IMPORTANT: Use steel gloves to hold the blade.
UPPER WHEEL: Remove the blade, after, hold strongly the Upper Wheel #05 (Pic.01), push it vertically up
and then pull it towards the saw front side.
LOWER WHEEL: Remove the Staple #01 (Pic.08) hold strongly the Lower Wheel and pull it towards the saw
front side (Pic.09).
BLADE SCRAPER: Slide the Blade Scraper sideway until it gets out.
WHEEL SCRAPER: Remove the Lower Wheel, then pull the Scraper towards the saw front side until it gets
out.
BLADE TENSION REGULATOR: Stand behind the saw and remove the Upper Back Cover #01 (Pic.10).
Turn the Blade Tension Regulator Handle #02 (Pic.11) counter clockwise until the Blade Tension Regulator #01
(Pic.11) gets free to be removed. Also remove the Blade Tension Regulator Handle #02 (Pic.11).
• Wash all the parts with water and neutral ph detergent.
IMPORTANT:
Do not spray water directly on the Lower Bearing, the Control Board and the Motor Housing #20
(Pic.01), principally at the ventilation points.
Use clean clothes or soft brushes to remove residues. Washing and sanitization shall be regularly performed
and then all parts shall be carefully dried. To assemble the several parts removed proceed inversely as above
instructed, make sure all parts to be properly assembled.
CAUTIONS WITH STAINLESS STEEL
The Stainless Steel may present rust signs, which ARE ALWAYS CAUSED BY EXTERNAL AGENTS,
especially when the cleaning or sanitization is not constant and appropriate. The Stainless Steel resistance
towards corrosion is mainly due to the presence of chrome, which in contact with oxygen allows the formation
of a very thin protective coat. This protective coat is formed through the whole surface of the steel, blocking the
action of external corrosive agents. When the protective coat is broken, the corrosion process begins, being
possible to avoid it by means of constant and adequate cleaning. Cleaning must always be done immediately
after using the equipment. For such results, use water, neutral soap or detergent, and clean the equipment with
a soft cloth or a nylon sponge. Then rinse it with plain running water, and dry immediately with a soft cloth, this
way avoiding humidity on surfaces and especially on gaps. The rinsing and drying processes are extremely
important to prevent stains and corrosion from arising.
IMPORTANT: Acid solutions, salty solutions, disinfectants and some sterilizing solutions (hypochlorites,
tetravalent ammonia salts, iodine compounds, nitric acid and others), must be AVOIDED, once it cannot remain
for long in contact with the stainless steel.
These substances attack the stainless steel due to the CHLORINE on its composition, causing corrosion spots.
Even detergents used in domestic cleaning must not remain in contact with the stainless steel longer than the