Omax MAXJET 5i 320303 Series, Руководство по установке и обслуживанию

Страница: 12 / 32

400715D-EN
12
NOTICE
Do not over or under tighten the nozzle body. Tighten the nozzle body to the specified torque. Under
tightening can cause leaks and equipment damage. Over tightening damages the sealing surface between
the orifice assembly and the nozzle filter assembly. Do not tighten the nozzle body to more than 25 ft-lb
(34 N·m).
6. Hold the A-Jet to counteract the torque, then tighten the nozzle body .
Figure 10
7. Install the mixing tube . See Install the Mixing Tube .
8. Connect the abrasive feed tube to the nozzle and the abrasive hopper , if needed. Make sure the abrasive
tube is inserted through the slot in the nozzle flap splash guard .
Figure 11
9. Recalibrate the A-Jet . See 400610 A-Jet Users Guide .
Install the Nozzle Body on a Motorized Z-Axis
NOTICE
Remove the mixing tube BEFORE installing or removing the nozzle to prevent damage. Large upward
forces from an installed mixing tube can misalign the internal nozzle components.
1. Remove the mixing tube if it is installed in the nozzle body . See Remove the Mixing Tube .
NOTICE
Handle the nozzle carefully to prevent damage to the abrasive tubing retention tube.