Omax MAXJET 5i 320303 Series, Руководство по установке и обслуживанию

Страница: 16 / 32

400715D-EN
16
NOTICE
Do not over or under tighten the nozzle body. Tighten the nozzle body to the specified torque. Under
tightening can cause leaks and equipment damage. Over tightening damages the sealing surface between
the orifice assembly and the nozzle filter assembly. Do not tighten the nozzle body to more than 25 ft-lb
(34 N·m).
6. Hold the top of the inlet body to counteract the torque, then tighten the nozzle body .
Figure 21
7. Install the mixing tube . See Install the Mixing Tube .
8. Connect the abrasive feed tube to the nozzle and the abrasive hopper , if needed.
Figure 22
Install the Mixing Tube
Replace the mixing tube when the cutting performance degrades beyond adjustment of the tool offset. Cut a kerf check
part, then measure and examine it for dimensional differences.
NOTICE
Remove the mixing tube BEFORE installing or removing the nozzle to prevent damage. Large upward
forces from an installed mixing tube can misalign the internal nozzle components.