Olympus Stylus 730, Руководство для продвинутых пользователей

Страница: 45 / 80

EN
45
Usi
ng OLYMPUS Mast
er
Operating environment
Windows
OS Windows 98SE/Me/2000 Professional/XP
CPU Pentium III 500 MHz or later
RAM 128 MB or more (at least 256 MB is recommended)
Hard disk capacity 300 MB or more
Connector USB port
Monitor 1,024 × 768 pixels, 65,536 colors or more
Note
• Windows 98 is not supported.
• Data transfer is only guaranteed on computers with a factory installed OS.
• To install the software in Windows 2000 Professional/XP, you must log on as a user with
administrators’ privileges.
• Internet Explorer and QuickTime 6 or later should be installed on your computer.
• Windows XP corresponds to Windows XP Professional/Home Edition.
• Windows 2000 corresponds to Windows 2000 Professional only.
• If you are using Windows 98SE, the USB driver is installed automatically.
Macintosh
OS Mac OS X 10.2 or later
CPU Power PC G3 500 MHz or later
RAM 128 MB or more (at least 256 MB is recommended)
Hard disk capacity 300 MB or more
Connector USB port
Monitor 1,024 × 768 pixels, 32,000 colors or more
Note
• Mac versions earlier than OS X 10.2 are not supported.
• Operation is only guaranteed on a Macintosh equipped with a built-in USB port.
• QuickTime 6 or later and Safari 1.0 or later must be installed.
• Be sure to remove the media (drag & drop onto the trash icon) before performing the following
operations. Failure to do so could result in unstable computer operation and the need to reboot.
• Disconnect the cable connecting the camera to the computer
• Turn off the camera
• Open the camera’s battery compartment/card cover
Windows
1
Insert the CD-ROM into the CD-ROM drive.
• The OLYMPUS Master setup screen is displayed.
• If the screen is not displayed, double-click the “My
Computer” icon and click the CD-ROM icon.
2
Click “OLYMPUS Master”.
• The QuickTime installation screen is displayed.
• QuickTime is required to use OLYMPUS Master. If the
QuickTime screen is not displayed, QuickTime 6 or later
is already installed on the computer. In this case, go to
step 4.