Olympus PT-033, Инструкция по эксплуатации

Страница: 62 / 291

E-23
Now everything is all right!
Have a nice dive!
Final Test
The final test after loading the camera is explained below. This is the only way to
eliminate worry about possible entry of water! Always perform this test. It can be
performed easily in a water tank or a bathtub. The required time is about five minutes.
Simple water immersion test Explanatory image Hints
1
Place the Case
slowly into the water.
As the Case is transparent,
waterdrops entering into it can be
confirmed easily.
2
At first, immerse the
Case for only three
seconds.
In case of trouble with the O-ring,
three seconds are enough for water
to enter. Are there air bubbles
coming out between the lids?
Please check carefully.
3
Check that no water
has entered into the
Case.
Remove the Case from the water and
check that no water has accumulated at
the bottom of the Case.
Is there any water trickling down?
4
Next, immerse the
Case for 30
seconds. Check carefully for air bubbles!
Do not perform any operation yet,
but just observe.
5
Check that no water
has entered.
Remove the Case from the water and
check that no water has accumulated
at the bottom of the Case.
Perform very careful confirmation.
6
Next, check by
immersing for three
minutes.
Check carefully for air bubbles!
Try operation of the buttons used frequently.
Check carefully for air bubbles!
If there is still no entry of water,
everything is OK!
7
This is the final check.
Has the silica gel
become moist?
This is very important!
Has the silica gel become moist?
Please check carefully!
As the inside can be seen, the inspection for
entry of water also can be made securely!
8
Now everything is
all right.
Note : The PT-033 is not provided with a balance weight.
PT033̲E.qxd 06.2.23 8:36 PM ページE-23