Olympus Dock & Done S-DVD-100, Руководство пользователя, Страница: 15 / 156

EN-15
Read
t
h
is
first
Precautions
Precautions
Handling the unit
• When writing data or in standby mode, if the following operations or phenomenon occur, data may be
corrupted.
And, even if the disk was written correctly, the disk management information may not be read correctly.
- A power failure occurs
- The power was turned off, or the AC adapter was removed while processing.
- The USB cable connected to the personal computer and the unit was disconnected while processing (in
PC mode).
- The Dock&Done mode/ PC mode switch was changed without performing a PC hardware removal, or
without removing the disk (in PC mode).
• Do not leave the tray extended. The build-up of debris and dust in the interior may cause malfunction.
• Do not place disks other than those which are compatible to the unit into the tray. Doing so may result in
malfunction.
• Do not place objects in front of the tray. Obstructing the tray extension and withdrawal action may cause
malfunction.
• Do not touch the internal lens. Doing so may cause malfunction of data reading and writing.
Handling disks
Disk may be easily damaged by scratching, impact, or temperature and this may cause loss of stored/copied
data. Be sure to observe the following precautions.
• Do not leave the disks in the following kinds of locations:
- locations with a lot of debris or dust,
- locations of high temperature and humidity,
- locations subject to direct sunlight, nor
- locations subject to extreme temperature differences (condensation may be produced).
• Do not leave the disks lying about unprotected. Always store disks in their protective cases.
• Do not allow the surface of the disk to become fouled with dirt, debris, fingerprints, or scratches.
• Do not drop or bend the disks. Also, do not stack the disks or place objects on top of the disks.
• Do not touch the recording side of a disk. Hold a disk by the center hole and the edge.
• When writing or drawing on the disk label, use a soft oil-based felt pen. Do not use a pen with hard point
such as a ball-point pen.
• If the disk gets dirty, wipe it with a soft cloth from the center toward the outside. Do not use solvents such
as thinner or benzine.
• Always back up the stored data on the disks periodically as insurance against disk degradation and loss of
data.
• We are not responsible for any damaged or loss of contents stored/copied on disks.