ASSEMBLY
/ DIP switch settings on control box (BX61, BX62 and BX61W1 only)
II.
DSU
II .
8 - 2 3
Page
8-21 DIP switch settings on control box (BX61, BX62 and BX61W1 only)
DIP switch settings should be done after power of control box is
turned OFF.
When you use BX61, BX62 or BX61W1, you must change DIP switch settings on control
box. Set in accordance with the following procedures.
1.
Peel off the seal in front of SW1.
2.
Change DIP switch 7 to ON.
3.
Attach front seal to SW1.
8-22 Installation of motor drive board
You must install motor drive board after you turn power of control
box to OFF.
1.
Loosen four fixing knobs for two option slot covers at left side of back panel
of control box (1) and remove covers and knobs.
2. Aligning
direction
of
connector inside control box with connector (2), insert
the board along with board rails.
Push the board until connectors of motor drive board are inserted into
connectors of mother board inside the control box.
3.
Using knobs you removed, fix motor drive board (2).
Likewise, attach the other cover (3).
Slot cover section must overlap. Attach cover from left side,
seen from back side.
Keep one piece of slot cover that remained with care as it
may be required for motor drive board when it is removed.
Note
(1)
(2)
(3)
Note
Note
Note